Money A2Z Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Ten-code - Wikipedia

    en.wikipedia.org/wiki/Ten-code

    10-22 Off Radio Unit is not capable of being contacted by radio, but may be "available." 10-7B On Radio Unit is capable of being contacted by radio, but not necessarily "available." 10-11 Responding Unit is en route to assigned location. 10-17 Under Control Situation is under control when no further assistance is anticipated. - -

  3. Radio control - Wikipedia

    en.wikipedia.org/wiki/Radio_control

    Radio control (often abbreviated to RC) is the use of control signals transmitted by radio to remotely operate a device. Examples of simple radio control systems are garage door openers and keyless entry systems for vehicles, in which a small handheld radio transmitter unlocks or opens doors. Radio control is also used for control of model ...

  4. Radiotelephony procedure - Wikipedia

    en.wikipedia.org/wiki/Radiotelephony_procedure

    The United States has been assigned all call signs with the prefixes K, N, and W, as well as AAA–ALZ. Allocating call signs within these groups is the responsibility of the National Telecommunications and Information Administration (almost all government stations) or the Federal Communications Commission (all other stations), and they subdivide the radio call signs into the following groups:

  5. X10 (industry standard) - Wikipedia

    en.wikipedia.org/wiki/X10_(industry_standard)

    X10 is a protocol for communication among electronic devices used for home automation ( domotics ). It primarily uses power line wiring for signaling and control, where the signals involve brief radio frequency bursts representing digital information. A wireless radio -based protocol transport is also defined.

  6. Continuous Tone-Coded Squelch System - Wikipedia

    en.wikipedia.org/wiki/Continuous_Tone-Coded...

    In an FM two-way radio system, CTCSS encoder levels are usually set for 15% of system deviation. For example, in a 5 kHz deviation system, the CTCSS tone level would normally be set to 750 Hz deviation. Engineered systems may call for different level settings in the 500 Hz to 1 kHz (10–20%) range.

  7. R-S-T system - Wikipedia

    en.wikipedia.org/wiki/R-S-T_system

    The R-S-T system is used by amateur radio operators, shortwave listeners, and other radio hobbyists to exchange information about the quality of a radio signal being received. The code is a three digit number, with one digit each for conveying an assessment of the signal's readability, strength, and tone. [1] [2] The code was developed in 1934 ...

  8. Rolling code - Wikipedia

    en.wikipedia.org/wiki/Rolling_code

    Simple remote control systems use a fixed code word; the code word that opens the gate today will also open the gate tomorrow. An attacker with an appropriate receiver could discover the code word and use it to gain access sometime later. More sophisticated remote control systems use a rolling code (or hopping code) that changes for every use.

  9. Brevity code - Wikipedia

    en.wikipedia.org/wiki/Brevity_code

    The codes' procedure words, a type of voice procedure, are designed to convey complex information with a few words, when brevity is required but security is not. Ten-code, North American police brevity codes, including such notable ones as 10-4. Phillips Code. NOTAM Code. Wire signal, Morse Code abbreviation, also known as 92 Code.

  10. Regulation of radio broadcast in the United States - Wikipedia

    en.wikipedia.org/wiki/Regulation_of_radio...

    Radio regulation in the United States was enforced to eliminate different stations from broadcasting on each other's airwaves. Regulated by the Federal Communications Commission, standardization was encouraged by the chronological and economic advances experienced by the United States of America. Commenced in 1910, before the Communications Act ...

  11. Emergency service response codes - Wikipedia

    en.wikipedia.org/wiki/Emergency_service_response...

    In the United States, response codes are used to describe a mode of response for an emergency unit responding to a call. They generally vary but often have three basic tiers: Code 3: Respond to the call using lights and sirens. Code 2: Respond to the call with emergency lights, but without sirens. Alternatively, sirens may be used if necessary ...